Configuration Parameters

What is the --audit-log-candidate parameter and how is it used?
The audit-log-candidate parameter for netconfd-pro dictates whether transactions to the candidate datastore will be recorded in the audit log. If set ...
Tue, 1 May, 2018 at 9:26 AM
What is the --audit-log-console-level parameter and how is it used?
The audit-log-console-level parameter for netconfd-pro sets the minimum logging level needed to log datastore audit records to the server console log. ...
Tue, 1 May, 2018 at 9:27 AM
What is the --audit-log-events parameter and how is it used?
The –audit-log-events parameter controls the event types that are output to the audit log.  This parameter uses the YANG “bits” type, so any combination of ...
Tue, 23 Apr, 2019 at 11:59 AM
What is the --audit-log-level parameter and how is it used?
The audit-log-level parameter for netconfd-pro sets the minimum logging level needed to log datastore audit-records to the audit log. This does not af...
Tue, 1 May, 2018 at 9:27 AM
What is the --autodelete-pdu-error parameter and how is it used?
If the autodelete-pdu-error parameter for netconfd-pro is set to "true", then configuration nodes provided in the edit payload (e.g., <conf...
Wed, 13 Sep, 2017 at 4:51 PM
What is the --binary-display-maxlen parameter and how is it used?
The --binary-display-maxlen parameter specifies the maximum number of bytes to display when dumping the contents of a binary value. Normally a message will ...
Tue, 23 Apr, 2019 at 3:57 PM
What is the --bundle parameter and how is it used?
The bundle parameter for netconfd-pro is used to name a Server Instrumentation Library (SIL) bundle to load at boot time. A SIL bundle is 1 SIL library for...
Wed, 7 Apr, 2021 at 9:25 PM
What is the --callhome-reconnect parameter and how is it used?
The –callhome-reconnect parameter specifies whether server will reconnect after client closes the session. If 'true' the server will attempt to st...
Tue, 23 Apr, 2019 at 4:06 PM
What is the --callhome-retry-interval parameter and how is it used?
YumaPro SDK 17.10 introduces support for the Call Home protocol defined in IETF RFC 8071.  By default, Call Home is not enabled but must be configured by t...
Wed, 25 Aug, 2021 at 9:39 AM
What is the --callhome-retry-max parameter and how is it used?
YumaPro SDK 17.10 introduces support for the Call Home protocol defined in IETF RFC 8071.  By default, Call Home is not enabled but must be configured by t...
Wed, 25 Aug, 2021 at 9:40 AM